Rockwell Automation 1756-CN2R ControlLogix ControlNet Interface Module Series A Installation Instructions - Manual (Page 11)

ControlLogix ControlNet Bridge Module 11
Publication 1756-IN602A-EN-P - November 2005
Install the Module
1 . Align the circuit board with top and bottom guides in the
chassis.
2. Slide the module into the chassis.
Make sure the module backplane connector properly connects
to the chassis backplane.
The module is properly installed when it is flush with the power
supply or other installed modules.
ATTENTION
Do not force the module into the backplane connector. If
you cannot seat the module with firm pressure, check the
alignment. Forcing the module into the chassis can
damage the backplane connector or the module.
1
2
Circuit
Board