Rockwell Automation 1756-CN2R ControlLogix ControlNet Interface Module Series A Installation Instructions - Manual (Page 9)

ControlLogix ControlNet Bridge Module 9
Publication 1756-IN602A-EN-P - November 2005
Set the Module’s Network Address Switches
Use your fingers or a small screwdriver to set the module’s network
address switches. For modules in a standalone chassis, you must
specify a unique ControlNet network address. You can select an
address of 01 to 99 for modules in a standalone chassis. Note that 00
is an invalid ControlNet address.
Prepare the Chassis for Module Installation
Before you install the 1756-CN2 module, you must install and connect
a ControlLogix chassis and power supply. A 4-slot chassis with a
power supply is shown below.
side of module
fr
ont
of
mo
dule
top of module
This module’s network
address is 23.
Chassis
Power
Supply