Rockwell Automation 1756-CN2R ControlLogix ControlNet Interface Module Series A Installation Instructions - Manual (Page 18)

18 ControlLogix ControlNet Bridge Module
Publication 1756-IN602A-EN-P - November 2005
Remove the Module
Follow these steps to remove the module:
1 . Push on the upper and lower tabs to disengage them.
2. Slide the module out of the chassis.
IMPORTANT
If you are replacing an existing module with an identical
one, and you want to resume identical system operation,
you must install the new module with the same
ControlNet address in the same slot.
Upper Tab