Rockwell Automation 1762-Lxxxxx MicroLogix 1200 Programmable Controllers Installation Instructions - Manual (Page 8)

8 MicroLogix 1200 Programmable Controllers
Publication 1762-IN006C-EN-P - September 2009
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or non-hazardous
locations only. The following WARNING statement applies to use in hazardous locations.
Use only the following communication cables in Class I, Division 2 hazardous locations.
Catalog Number Description
Input Power Inputs Outputs
1762-L24AWA, -L24AWAR 120/240V ac (14) 120V ac (10) relay
1762-L24BWA, -L24BWAR 120/240V ac (10) 24V dc
(4) fast 24V dc
(10) relay
1762-L24BXB, -L24BXBR 24V dc (10) 24V dc
(4) fast 24V dc
(5) relay, (4) 24V dc FET
(1) high-speed 24V dc FET
1762-L40AWA, -L40AWAR 120/240V ac (24) 120V ac (16) relay
1762-L40BWA, -L40BWAR 120/240V ac (20) 24V dc
(4) fast 24V dc
(16) relay
1762-L40BXB, -L40BXBR 24V dc (20) 24V dc
(4) fast 24V dc
(8) relay, (7) 24V dc FET
(1) high-speed 24V dc FET
WARNING
EXPLOSION HAZARD
• Substitution of components may impair suitability for Class
I, Division 2.
• Do not replace components or disconnect equipment
unless power has been switched off.
• Do not connect or disconnect components unless power
has been switched off.
• This product must be installed in an enclosure. All cables
connected to the product must remain in the enclosure or
be protected by conduit or other means.
• All wiring must comply with N.E.C. article 501-4(b).