Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module Installation Instructions - Manual (Page 11)

11
Publication 1756-IN571B-EN-P - April 2001
Prepare the Chassis for Module Installation
Before you install the CNB module, you must install and connect a
ControlLogix chassis and power supply. A 4-slot chassis with a power
supply is shown below.
For information on installing these products, refer to the publications
listed in the following table.
Chassis
Type
Chassis
Installation
Power
Supply
Power Supply
Installation
Series B: 1756-A4, -A7, -A10, -A13 Pub. No.
1756-IN080
1756-PA72/B Pub. No.
1756-5.67
1756-PB72/B
1756-PA75/A Pub. No.
1756-5.78
1756-PB75/A
Chassis
Power
Supply