Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module Installation Instructions - Manual (Page 20)

20
Publication 1756-IN571B-EN-P - April 2001
Connecting a Programming Terminal to the Network Using 1786-CP Cable
To connect a programming terminal to the network using a 1786-CP
cable, you have the following options:
1. using a 1784-KTC, -KTCx, or -PCC communication card and a
1786-CP cable:
2. using a 1770-KFC communication interface, a serial or parallel
connection, and a 1786-CP cable:
IMPORTANT
To work properly, the primary and redundant
partner module must be connected to the same
network segment. If you are using redundant
media, connect the channel of each partner to the
same network segment.
1756-CNBR
1786-CP Cable
1784-KTC, KTCx,
PCIC, or PCC card
ControlNet link
1756-CNBR
1786-CP (1)
ControlNet link
Cable
1770-KFC
Serial or parallel
connections