Removing or replacing the module (if needed), Connect the module to the network – Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module Installation Instructions User Manual
Page 15
Advertising

15
Publication 1756-IN571B-EN-P - April 2001
Removing or Replacing the Module (if needed)
If you are replacing an existing module with an identical one, and
you want to resume identical system operation, you must install the
new module with the same ControlNet address in the same slot.
Connect the Module to the Network
You can connect the module to the ControlNet network using a tap
(1786-TPR, -TPS, -TPYR, -TPYS) or a network access cable (1786-CP).
TIP
Use the 1786-CP cable for temporary connections
(i.e., programming software). For permanent
connections, use a tap.
Upper tab
Push on the upper and lower tabs
to disengage them. Then slide
the module out of the chassis.
Advertising
This manual is related to the following products: