Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module Installation Instructions - Manual (Page 14)

14
Publication 1756-IN571B-EN-P - April 2001
Install the Module
ATTENTION
!
Do not force the module into the backplane
connector. If you cannot seat the module with
firm pressure, check the alignment. Forcing the
module into the chassis can damage the
backplane connector or the module.
Align the circuit board with top
and bottom guides in the chassis.
Slide the module into the chassis.
Make sure the module backplane
connector properly connects to
the chassis backplane. The module is properly installed
when it is flush with the power
supply or other installed modules.
Circuit
board