Rockwell Automation 20D-DL2-CKS1 Import/Export Project Components - Manual (Page 17)

Import and export logic components Chapter 1
The following screen capture shows a typical Import Configuration dialog box.
Your dialog box might contain options different than those shown here,
depending on the component you import.
An import component collides with an existing component if a component of the
same type, scope, and with the same name exists in the project. By configuring the
Final Name of the imported component, you determine whether the imported
component collides with an existing component, or it does not (if a component of
the same type, scope and with the same name does not exist in the project). For a
collision, you can use the existing project component or you can overwrite it. For a
non-collision, you can create a project component or you can discard, and not
import, the component from the import file. In any case, any imported logic
references are updated to be the same as the Final Name.
By configuring the Operation for the component, you determine whether it is
imported from the file or an existing component is used. Incompatibility of a
Rockwell Automation Publication 1756-PM019E-EN-E - October 2014 17