Rockwell Automation 20D-DL2-CKS1 Import/Export Project Components User Manual
Page 25
Import and export logic components Chapter 1
In My Original Project, the parameters in Program1 are connected to parameters
in Program2.
When you import the original Program1 into My New Project, the parameters in
Program1 connect automatically to matching parameters in Program2. Parameters
that do not match are flagged as errors. You need to change the Final Connector
for those parameters.
If the endpoint names are different in My New Project (for example, Program3)
you can either open the Connections grid and change the Final Connection
name on the endpoints from Program2 to Program3, or you can go to the
References grid and change the final name on Program2 to Program3 in one place,
and all the connections change automatically.
Rockwell Automation Publication 1756-PM019E-EN-E - October 2014
25