Rockwell Automation 20D-DL2-CKS1 Import/Export Project Components - Manual (Page 26)

Chapter 1 Import and export logic components
To open the Connections grid, click Connections on the Import Configuration
dialog box.
The following screen capture shows the Connections grid as it would appear
when you import Program1 into My New Project, as described earlier in this
section. To fix the connection errors, you can select Disconnect in the Operation
box, or you can select a different connection in the Final Connection box.
The indicator column at the far left of the Connections grid shows the condition
of the connection. The following table describes the connection conditions.
Indicator Connection Condition
* Indicates a row in which content has changed and the change has not been saved.
Indicates a row in which the connection endpoints are invalid due to a syntax error. If you click OK to
begin the import, you receive an error message and must fix or remove the connection before you can
proceed.
Indicates that the connection being imported will contain an error at the completion of the import. You
can proceed with the import, and the connection is created, but you must fix the error before you can
download the project to the controller.
Indicates a row in which you can create a connection.
The following table describes the Connections grid columns and settings.
26 Rockwell Automation Publication 1756-PM019E-EN-E - October 2014