Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module, Series E Installation Instructions - Manual (Page 22)

22 ControlLogix ControlNet Interface Module
Publication 1756-IN604A-EN-P - February 2006
Connect a Programming Terminal to the Network with a 1786-CP
Cable
To connect a programming terminal to the network using a 1786-CP cable,
you have the following options:
• Use a 1784-KTC, 1784-KTCx, or 1784-PCC communication card and
a 1786-CP cable:
• Use a 1770-KFC communication interface, a serial or parallel
connection, and a 1786-CP cable:
IMPORTANT
To work properly, the primary and redundant partner
module must be connected to the same network
segment. If you are using redundant media, connect the
channel of each partner to the same network segment.
1756-CNBR
1786-CP Cable
1784-KTC, KTCx,
PCIC, or PCC Card
ControlNet Link
1756-CNBR
1786-CP
ControlNet Link
Cable
1770-KFC
Serial or Parallel
Connections