Rockwell Automation 1756-CNB ControlLogix ControlNet Bridge Module, Series E Installation Instructions - Manual (Page 6)

6 ControlLogix ControlNet Interface Module
Publication 1756-IN604A-EN-P - February 2006
Prevent Electrostatic Discharge
For additional information, refer to Industrial Automation Wiring and
Grounding Guidelines, publication 1770-4.1.
About the 1756-CNB and 1756-CNBR Series E Modules
The 1756-CNB and 1756-CNBR Series E modules work for all nonredundant
ControlLogix applications.
ATTENTION
This equipment is sensitive to electrostatic discharge, which can
cause internal damage and affect normal operation. Follow these
guidelines when you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• If available, use a static-safe workstation.
• When not in use, store the equipment in appropriate static-safe
packaging.
IMPORTANT
Only the 1756-CNB and 1756-CNBR, Series D modules are
supported in ControlLogix Redundancy releases 8, 11, 13, and 15.
After a firmware upgrade to version 11.xx, Series E will be
supported in ControlLogix Redundancy release 15 or later.
You cannot upgrade a Series D module to a Series E module.