Rockwell Automation 1756-DH485 ControlLogix Data Highway 485 Module Installation Instructions - Manual (Page 14)

14 ControlLogix DH-485 Communications Module
Publication 1756-IN587A-EN-P - September 2005
Connect the 1761-NET-AIC Converter to the DH-485 Network
Use the RS-485 connector to connect the 1761-NET-AIC converter to the
DH-485 network. For more information on how to use the 1761-NET-AIC
convertor, see the following publications:
• Advanced Interface Converter (AIC+) and DeviceNet Interface
(DNI) Installation Instructions, publication 1761-IN002
• Advanced Interface Converter (AIC+) User Manual, publication
1761-6.4
Data Highway-485 Communications Connections
Apply Chassis Power
WARNING
If you connect or disconnect the DH-485 cable with power
applied to this module or any device on the network, an
electrical arc can occur. This could cause an explosion in
hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
ON
POWER
OFF
ON POWER OFF
43845