Rockwell Automation 1788-CNCR ControlNet Daughtercard Installation Instructions - Manual (Page 10)

10 ControlNet Daughtercard
Publication 1788-IN002C-EN-P - April 2004
Connect to the Network Using a Tap
1. Remove and save the dust cap(s) from the ControlNet tap(s).
ATTENTION
Do not allow any metal portions of the tap to contact any
conductive material. If you disconnect the tap from the module,
place the dust cap back on the straight or right angle connector
to prevent the connector from accidentally contacting a metallic
grounded surface.
segment 2
segment 1
1756-CNB use segment 1
1756-CNBR use segment 1 and segment 2
Note:
20955-M
dust cap
dust cap
trunk cable A
trunk cable B
1788-CNC use trunk cable A.
1788-CNCR use trunk cable A and B.