Connect to the network using a 1786-cp cable – Rockwell Automation 1788-CNCR ControlNet Daughtercard Installation Instructions User Manual
Page 12
12 ControlNet Daughtercard
Publication 1788-IN002C-EN-P - April 2004
Connect to the Network Using a 1786-CP Cable
Follow this illustration to connect a programming terminal to the network using a 1786-CP
cable.
ATTENTION
Use the 1786-CP cable when you connect a programming terminal to the
network through the network access port (NAP); using another cable
could result in possible network failures or product damage.
The NAP port is for temporary local programming purposes only and not
intended for permanent connection.
1786-CP
cable
Any ControlNet
interface card
B
A
ControlNet network
1
1
The 1786-CP cable can be plugged into any ControlNet product's NAP to provide programming
capability on the ControlNet network. A programming terminal connected through this cable is
counted as a node and must have a unique address.
31074-M