Installing the card, Connecting the card to the network, Daughtercard performance – Rockwell Automation 1788-CNCR ControlNet Daughtercard Installation Instructions User Manual
Page 8
8 ControlNet Daughtercard
Publication 1788-IN002C-EN-P - April 2004
Installing the Card
Due to wide variation in available host devices, we cannot provide specific installation
instructions in this document. For instructions on how to install the daughtercard in a host
device, refer to the user manual for the particular host device.
Daughtercard Performance
Due to wide variation in available host devices, we cannot provide specific performance
capabilities in this document. For information concerning host/daughtercard performance
characteristics, refer to the user manual for the particular host device.
Connecting the Card to the Network
After you have installed the card, you can connect it to the network. You must connect the
card to the network using an approved ControlNet tap:
• 1786-TPR (T-tap right angle)
• 1786-TPS (T-tap straight)
• 1786-TPYR (Y-tap right angle)
• 1786-TPYS (Y-tap straight)
We recommend the straight taps.
IMPORTANT
Do not install or remove the daughtercard while the host is under power.