Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 107)

5–23 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
The Pass-Through Control Byte is also displayed, if it is defined in
the current application.
View the terminal settings and PLC information of the current DH+
application file in the Terminal Network Setup screen.
To view the terminal network settings:
" In the Terminal Configuration screen, choose the Terminal
Network Setup button.
Important: For information to be displayed on the screen, an
application must be made current (selected).
The terminal network address and baud rate at which you are
communicating are displayed at the top of the screen. To change the
terminal network address, use the Up and Down arrows. To change
the baud rate to 57.6K, 115.2K, or 230.4K, use the Baud Rate button.
The default baud rate setting is 57.6K.
All nodes (devices) with which your application will communicate
are listed. The terminal network address, Device Type, and Timeout
are displayed in the window. Use the Prev and Next buttons to scroll
through the entries in this window.
Terminal Network Setup
for DH+ Applications