Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 139)

5–55 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
To cause the selected application to write out its initial values:
" Choose the Load Application Initial Values button. This allows
the selected application to write out its initial values on the next
entry to Run mode.
Note: This button is disabled if a current application has not been
specified.
To restore the terminal configuration defaults:
" Choose the Load Terminal Configuration Defaults button.
The default values are restored for the following screens:
•
Transfer Setup
•
Application Startup
•
Security
•
Time and Date
•
Terminal Response
•
Printer
•
Align Screen
Note: If an application is currently selected, the network
communication Baud Rate and terminal network address will be
retrieved from the application file and stored in the terminal’s
parameters.
To open the Upgrade Firmware screen, choose the Upgrade
Firmware button in the Terminal Configuration screen.
For PanelView keypad terminals, the following Upgrade Firmware
screen appears.
"
"
Upgrading Firmware