Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 119)

5–35 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
Button Audio, Alarm Audio, Audio Volume
The terminal can sound a beep whenever you choose an active touch
cell or function key. The PLC controller can also trigger this audio
indicator either directly with the PLC Controlled Audio, or through
an alarm message.
To change audio settings:
1. Disable Button Audio or Alarm Audio, or to change the Audio
Volume, choose the corresponding button or function key.
•
Button Audio
ĊThe default setting is On. The terminal beeps
each time you choose a button.
•
Alarm Audio
ĊThe default setting is On. Both the PLC
Controlled Audio bit and alarm triggered audio can cause the
terminal’s built-in audio indicator to beep. Changing this to
Off will disable both the alarm triggered audio and PLC
Controlled Audio operation (see your PanelBuilder 1400e
Configuration Software for Windows User Manual for details).
•
Audio Volume
ĊThe default setting is High. You can change
this to Low.
2. Choose OK to save your settings.
Alarm Settings
The alarm relay can be wired to an external alarm or warning light.
You control the relay by configuring an alarm message to activate it,
or by defining a PLC Controlled Relay output bit (see your
PanelBuilder 1400e Configuration Software for Windows User
Manual for details).
You can set the number of alarm history records you want displayed
on your terminal. You can display 128, 500, 1000, 1500, or 2500
alarm history records on your terminal.
In Alarm Settings, you can also enable or disable the Clear All
button and Acknowledge All button on the Alarm History screen.