Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 91)

5–7 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
2. To change the settings, choose the Baud Rate, Parity, or Error
buttons to move the check mark to the setting you want.
•
Baud Rate
ĊThe speed at which data is transmitted over the
serial cable. The default setting for a serial transfer is 9600
baud.
•
Parity
ĊUsed to check data transferred between the
development computer and terminal. The default setting is
None.
•
Error
ĊUsed to check for errors in data transmission and is
either
– CRC
Ċcyclical (or cyclic) redundancy check.
– BCC
Ċblock check character. BCC is the default setting.
3. When you have selected the required settings, choose OK to exit
this screen.
For detailed instructions on configuring the computer’s serial port,
see the PanelView e Transfer Utility User Manual.
To transfer an application serially:
1. In the Terminal Configuration screen, choose the Transfer
Application button to display the Transfer Application screen.
For PanelView keypad terminals, the following Transfer
Application screen appears.