Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 79)

4–12 Installing PanelView 1400e Terminals
Publication 2711E-6.17 – November 1998
Connecting the Dataliner
Figure 4.10 shows the connection between a PanelView RS-232 port
and a Dataliner display device. See the Dataliner manual for more
information.
Figure 4.10 PanelView RS-232 Port and Dataliner
Connection
Connecting an External Alarm Relay
The PanelView 1400e terminal can be used to trigger a remote alarm
or warning light under specific conditions. See Appendix C for the
voltage range of the alarm relay.
See Figure 4.1 for the location of the alarm relay connector on the
back of the terminal.
!
ATTENTION: Do not use this relay for control
functions of any kind.
To attach a remote alarm or light to the alarm relay connector:
1. Prepare the wires by stripping them of their insulation to a length
of
½ to ¾ of an inch (1 to 2 cm).
2. Turn the screw on the alarm relay connector counterclockwise to
open the wire slot.
3. Insert the wire fully into its appropriate slot. See Figure 4.11 for
an illustration.
4. Turn the screw clockwise until the wire is held firmly in place.
5. Repeat the procedure until all three wires are connected.