Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 116)

5–32 Configuring PanelView Terminals
Publication 2711E-6.17 – November 1998
To set the time:
1. Make sure the Time screen is open.
2. On the left side of the screen, make your selections for Format,
Show Seconds, and Leading Digit. The defaults are 12-hour
Format, Yes for Show Seconds, and Zero for Leading Digit.
3. Use the Up and Down arrows to select hours, minutes, and
seconds. You must enter the time in 24-hour format.
4. Choose OK to set the terminal’s time.
The time will ‘tick over’ as you set it, but the terminal’s clock is
not set until you choose OK.
To format the Date:
1. Select the Date tab to open the Date screen.
For PanelView keypad terminals, the following Time and Date
screen appears.