Rockwell Automation 2711E-xxxx User Manual PanelView 1000e, 1200e 1400e - Manual (Page 68)

Chapter
4
Publication 2711E-6.17 – November 1998
Installing PanelView 1400e
Terminals
This chapter describes how to install a PanelView 1400e terminal.
Specifically, it provides:
•
terminal dimensions
•
a list of tools for installing the terminal
•
cutout dimensions for panel mounting
•
details about mounting options
This chapter also provides specific information about the correct use
of the following hardware features, including:
•
how to adjust contrast and brightness
•
how to adjust horizontal and vertical position
•
how to switch modes
•
how to connect power to the terminal
•
how to connect the Upload/Download cable
•
how to connect a serial printer
•
how to connect the Dataliner
•
how to connect an external alarm relay
•
how to connect a terminal to your PLC system
•
how to connect a keyboard and/or a bar code reader
Refer to Chapter 1 for information about the Upload/Download
cable, remote keyswitch assembly, and PCMCIA memory card slot
kits.
Figure 4.1 shows the rear panel of the PanelView 1400e terminal.
Overview