Rockwell Automation 6176M-xxxx Standard Industrial Monitors Installation Instructions - Manual (Page 11)

Industrial Standard Monitors 11
Rockwell Automation Publication 6176M-IN001E-EN-P - August 2012
Mounting a VESA Monitor to a Bench or Tabletop
Use the optional bench/tabletop adapter for monitors, catalog number 6189V-MBA, to mount
your VESA monitor on a bench or tabletop.
Mounting Guidelines
Observe these guidelines when installing the VESA monitor on an arm:
•
The mounting surface and the mounting arm must be strong enough to support both the
monitor and the mounting hardware.
•
The interface between the arm and the monitor must meet VESA FPMPMI 100 mm
(3.94 in.) standards.
•
The mounting location must provide adequate clearance for positioning and moving the
adjustable unit and for routing cables.
Mounting the Monitor on a Bench or Tabletop
Follow these directions to mount the VESA monitor to a bench or tabletop.
1. Mount the arm to the bench or tabletop by using screws, bolts, or clamps so the monitor
cannot tip.
2. Place the monitor over the arm and insert the four supplied VESA mounting screws
through the arm brackets and into the monitor.
The illustration shows the mounting holes for VESA FPMPMI standard
100 mm (3.94 in.) interface pad.
3. Tighten the screws to secure the VESA monitor to the arm.
Monitor Mounting Holes (4)
Installing Arm Installing Monitor to Arm