Rockwell Automation 2711-PV1000 PanelView 1000 Terminals - Manual (Page 9)

PanelView 1000 Terminals 9
Publication 2711-IN036J-EN-P - November 2009
1. Cut an opening in the panel using the panel cutout provided with the terminal.
Remove any sharp edges or burrs.
2. Make sure the terminal sealing gasket is properly positioned on the terminal as shown
below. This gasket forms a compression type seal. Do not use sealing compounds.
3. Although the keypad legend insert can be installed any time, we recommend that you
install it after the terminal is installed.
4. Place the terminal in the panel cutout.
5. Install the 6 mounting clips (2 on top, 2 on bottom, 1 on each side); the ends of the
clips slide into the slots on the terminal. Tighten the clip mounting screws by hand
until the gasket seal contacts the mounting surface uniformly.
Sealing Gasket
Install 6 Mounting Clips:
Top - Left and Right Slots
Bottom - Left and Right Slots
Sides - Left and Right Slots
Protective Installation Labels