Rockwell Automation 2094-SEPM-B24-S Kinetix 6000M IDM Power Interface Module - Manual (Page 4)

4 Kinetix 6000M Integrated Drive-Motor Power Interface Module
Publication 2094-IN016A-EN-P - February 2012
Before You Begin
Remove all packing material, wedges, and braces from within and around the components. After
unpacking, check the item nameplate catalog number against the purchase order.
Parts List
Install the IPIM Module
This procedure assumes you have prepared your panel, mounted your Bulletin 2094 power rail,
and understand how to bond your system. For installation instructions regarding equipment and
accessories not included here, refer to the instructions that came with those products.
The Bulletin 2094 power rail comes in lengths to support one IAM module and up to seven
additional modules. A maximum of four IPIM modules can be mounted to a single power rail.
The connector pins for each slot are covered by a protective cover. The cover is designed to
protect the pins from damage and make sure that no foreign objects lodge between the pins
during installation. Refer to the Kinetix 6000 Power Rail Installation Instructions, publication
2094-IN003 , when installing your power rail.
Component Ships with
IPIM module • Wiring plug connector set for DC bus, enable, and hybrid power/communication
• Wiring plug header and motion-allowed jumper for safe-off connector
• A 2090-CTHP8 hybrid terminator and 2090-CTSRP network terminator
• These installation instructions, publication 2094-IN016
SHOCK HAZARD: To avoid hazard of electrical shock, perform all mounting and wiring of the
Bulletin 2094 power rail and drive modules prior to applying power. Once power is applied,
connector terminals may have voltage present even when not in use.
ATTENTION: Plan the installation of your system so that you can perform all cutting, drilling,
tapping, and welding with the system removed from the enclosure. Because the system is of the
open type construction, be careful to keep any metal debris from falling into it. Metal debris or
other foreign matter can become lodged in the circuitry, which can result in damage to
components.
ATTENTION: To avoid damage to the power rail during installation, do not remove the protective
covers until the module for each slot is ready for mounting.