Rockwell Automation 6181X-12TPXPDC Industrial Integrated Computers for Hazardous Locations - Manual (Page 22)

22 Rockwell Automation Publication 6181X-UM001B-EN-P - May 2011
Chapter 2 Installation
Install the Computer The computers support these mounting options.
Mount the Non-display Computer on a Wall
Four mounting screws secure the non-display computer to a metal wall, such as a
steel mounting panel in an enclosure or equipment room.
Follow these steps to mount a non-display computer.
1. Disconnect power from the computer.
2. Attach two of the supplied M4 panhead screws with grommets
to the
1 and 2 screw position as illustrated below.
3. Mount the computer on the wall and then attach the remaining two M4
panhead screws with grommets to the
3 and 4 screw position.
4. Tighten the screws to a torque that is appropriate for the screw and wall.
Recommended torque in steel is 1.13…1.36 N•m (10…12 lb•in).
The illustration shows the location of the screw holes with the dimensions
given in mm (in.).
Cat. No. Computer Model Mounting Option
6181X-NPXPDC Non-display Wall mount
6181X-12TPXPDC
(1)
(1) Display computers must be securely mounted by using all mounting clips.
Display Panel mount
IMPORTANT Do not mount the non-display computer on a horizontal surface.
335.28 (13.2)
19
0.5
0 (7.
50
)