Rockwell Automation 6181X-12TPXPDC Industrial Integrated Computers for Hazardous Locations User Manual
Page 38
38
Rockwell Automation Publication 6181X-UM001B-EN-P - May 2011
Chapter 4 Component Replacement
4. Clip the cable tie of the existing memory module (A) and remove it from
the memory slot
(B).
5. Completely open the retaining latches securing the memory module (C).
This forces the module up in the slot and makes it easier to remove.
6. Gently remove the memory module from its slot (D).
7. Place the memory module on a static-dissipating work surface or inside an
antistatic bag.
8. Hold the new memory module by its edge and remove it from its
protective packaging.
9. Orient the module so that the notch on its bottom edge aligns with the
keyed surface of the DIMM1 slot
(E).
TIP
If you insert a memory module but it does not fit easily into the slot, you
may have inserted it incorrectly. Be sure of proper orientation and model
type and reinsert.
B
B
A
6181X-12TPXPDC Display Computer
C
C
D
6181X-12TPXPDC Display Computer