Rockwell Automation 6181X-12TPXPDC Industrial Integrated Computers for Hazardous Locations - Manual (Page 9)

Rockwell Automation Publication 6181X-UM001B-EN-P - May 2011 9
System Features Chapter 1
Parts List Your computer is shipped with these items:
• Mounting hardware
• Panel cutout template, display computer only
• Installation instructions
• Production test report
• System CDs
– Accessory CD with Cloning Utility (red)
– System Support CD with Diagnostic Utility (green)
– Microsoft Multilingual User Interface (MUI) CD Pack (gray, five cd-
pack), where applicable
Required Tools These tools are required for product installation:
• Panel cutout tools, display computer only
• #2 Phillips screwdriver
• Drill and M4 screw tap, non-display computer only
• Antistatic wrist strap (recommended)
Accessories and
Replacement Parts You can view a current list of accessories at this Rockwell Automation website
http://www.ab.com/industrialcomputers .
This table summarizes the product accessories options available for the industrial
integrated display computers.
Cat. No. Qty. Description
6181X-NPXPDC 4 M4 panhead screws with isolator grommets
6181X-12TPXPDC 10 Panel mounting clips
ATTENTION: Use only these specified catalog numbers in the 6181X
industrial computers for hazardous locations. Other replacements and
accessories are not acceptable for use in hazardous locations.
Cat. No. Description
6189X-MCLPS Mounting clips (10)
6189X-4GDDR2 4 GB RAM (2 x 2 GB)
6189V-CFSSD8GB CompactFlash card, 8 GB
6189V-CFSSD16GB CompactFlash card, 16 GB