Rockwell Automation 6180 RAC6180 Industrial Computers Installation Instructions - Manual (Page 15)

RAC6180 Industrial Computers 15
Publication 6180-IN001B-EN-P
6. Alternately tighten the self–locking nuts (use 3/8 inch socket) until the
RAC6180 is held firmly against the panel (see recommended
tightening sequence below). The studs have an integral spacer that
prevents the gasket from being over–compressed. The amount of
torque required increases significantly as the gasket reaches the proper
compression. Tighten nuts to a torque of 10 inch–pounds (1.1 N•m).
Note that sequence starts at center studs and continues to the corner studs.