Rockwell Automation 6180 RAC6180 Industrial Computers Installation Instructions - Manual (Page 4)

4 RAC6180 Industrial Computers
Publication 6180-IN001B-EN-P
Tools Required
In addition to the tools required to make the cutout, you will need the
following tools:
• 3/8 inch socket
• 14 inch (36 cm) extension rod (minimum)
• Socket driver (in/lb torque wrench recommended)
• 7/32 hex wrench
• Ruler
Mounting Clearances
Allow adequate space for mounting, air flow, and maintenance. Figure 1
on the following page shows recommended minimum clearances to other
components within the rack or enclosure.
ATTENTION: The RAC6180 should not be operated
within a confined space of the dimensions shown below
unless adequate ventilation or other cooling methods are
used to lower the air temperature within the enclosure.