Rockwell Automation 6180 RAC6180 Industrial Computers Installation Instructions - Manual (Page 18)

18 RAC6180 Industrial Computers
Publication 6180-IN001B-EN-P
6. Tighten mounting clips to a torque of 10 inch–pounds (1.1 N•m) in the
sequence shown above. Do not over–tighten.
ATTENTION: Tighten mounting clips to a torque of 10
inch pounds (1.1 N•m) to provide a proper seal and
prevent damage to the RAC6180. Rockwell Automation
assumes no responsibility for water or chemical damage
to the terminal or other equipment within the enclosure
because of improper installation.
Note: The mounting clips on the hinge side interfere with the
opening of the hinge. Remove the clips before opening the
hinge.