Rockwell Automation 2500 SecureConnect Units for CENTERLINE 2500 Low Voltage Motor Control Centers - Manual (Page 8)

8 Rockwell Automation Publication 2500-IN005B-EN-P - April 2012
SecureConnect Units for CENTERLINE 2500 Low Voltage Motor Control Centers
2. Slowly slide the unit into the column along the tracks on the unit support
pan until it locks in the Disconnected position.
Figure 2 - SecureConnect Handle Disconnect Position
3. Push the unit interlock lever inward to lock the unit to the unit support
pan.
4. Insert the link arm pin into the gear hole in the slot.
IMPORTANT Verify that the SecureConnect handle is in the correct Disconnected position as
shown in
Figure 2 .
Handle in correct Disconnected position Handle is overextended in Disconnected position
Push the unit interlock
lever inward.
Press
Before
Closing
Door
Label Detail
Link Arm Gear Hole
Link Arm
Decal Detail