Rockwell Automation 7000 PowerFlex Medium Voltage (B Frame) Commissioning - ForGe (PanelView 550) - Manual (Page 36)

32 Rockwell Automation Publication 7000-IN006B-EN-P - May 2013
Chapter 3 Initial Operator Interface Configuration
To change the minutes press [F5] again and repeat the procedure (repeat again to
change the seconds).
To abort the change, press [Backspace]. Press [Enter] to save the changes.
Setting Date
Like the clock, the calendar affects the date stamp on drive information appearing
on the alarm summary screen.
Figure 22 - Setting the calendar
The calendar uses the MM/DD/YY format.
To change the month, press [F4]. Press
▲
or
▼
to increment the calendar by 1
month. Press
◄
or
►
to increment the calendar by 10 months.
To change the day press [F4] again and repeat the procedure (repeat again to
change the year).
To abort the change, press [Backspace]. Press [Enter] to save the changes.
You can not set the day of the week. The interface determines the day of the week
based on your date selection.
Selecting Meters
The utility screen ( Figure 18 ) shows tags assigned to four meters on the top-level
menu. You can change these meters by pressing [F8] to configure meter selection,
as shown below.