Rockwell Automation 6185-C_B Industrial 15 12 Inch Monitor User Manual - Manual (Page 12)

12 Bulletin 6185-C and 6185-B Industrial Flat Panel Monitors
Publication 6185-5.1
Panel mount monitors are designed to provide protection against water
and dust to NEMA 4 (IP65) and NEMA 12 (IP53) standards.
Slides or shelves are not required because the panel mount monitor is
designed to be supported by the panel in which it is installed.
Note:
Using optional rack adapters, you can install the 6185-C
into a rack. For procedures, skip this section and see
Appendix A: Installing Your Monitor in a Rack on page 38.
Figure 3
Generic Panel Mount Diagram
Tools Needed
In addition to the tools required to make the panel cutout, you will need
the following tools:
•
3/8" deep well socket
•
¼" drive extension – 6" or longer
•
¼" drive ratchet or ¼" drive torque ratchet
Installing Your Monitor