Rockwell Automation 6185-C_B Industrial 15 12 Inch Monitor User Manual - Manual (Page 26)

26 Bulletin 6185-C and 6185-B Industrial Flat Panel Monitors
Publication 6185-5.1
Working with the OSD
Starting the OSD
1. Press the Select pushbutton to display the OSD.
Verifying Workstation Settings
You changed the settings in Setting Up Your Workstation on page 21.
This procedure verifies your selections.
1. Highlight the System Menu option using the up and down
pushbuttons and press Select.
2. Verify that you are using the desired settings:
•
Resolution of 1024x768 for 6185-C or 800x600 for 6185-B
works best
•
Vertical refresh rate of 60 or 75Hz.
3. If necessary, change the resolution or video refresh rate for the
workstation using the Windows Control Panel.
Using the Auto-Adjust Feature
Using the auto-adjust feature automatically adjusts the monitor correctly,
often requiring no additional changes.
1. Highlight the Auto Adjust option and press Select.
The monitor attempts to adjust the settings properly based on the
current signal. This process may take up to 20 seconds.
Verifying the Horizontal Size
Verify that the horizontal size is adjusted correctly. You should see
individual lines through the center section of the setup image. See the
figures in this section for detail:
Changing the horizontal size setting adjusts the width of the image on the
monitor from left to right; thus adjusting the sample rate of the monitor
to match the pixel clock rate of the workstation's video card.
1. Highlight the Position option and press Select.
2. Highlight the Horizontal Size option and press Select.
3. Adjust the horizontal size until the vertical shaded bars disappear.