Rockwell Automation 6185-C_B Industrial 15 12 Inch Monitor User Manual - Manual (Page 21)

Configuring Video Setup 21
Publication 6185-5.1
Figure 6
Monitor Video Adjustments
You may also need to adjust the brightness or contrast of the screen
image based on the conditions of the location in which the monitor is
installed.
Note:
The screen setup utility delivered with this flat panel
monitor is designed to present the "worst case" scenario for
graphic display. It shows a range of colors and presents a
pattern you can use to ensure that the monitor is adjusted
properly.
Note:
Flat panel monitors are not susceptible to magnetic
interference in the same way that CRT monitors are.
However, all monitors are susceptible to ground loop
problems between the computer and the monitor. Ground
loops occur when two or more devices with different
ground potentials are connected with cables and ground
currents flow between. These currents may cause vertical or
horizontal noise bars to move through the display screen.
Verify and change these settings for your workstation using the Windows
Control Panel.
To access monitor settings, select the Start button and select Settings to
access Control Panel. In Control Panel, select Display to access monitor
settings. The options on the Control Panel screens may vary depending
on your video driver.
Selecting the Monitor Type
If you are using Windows 95, Windows 98 or Windows 2000 and your
video card supports it, you should enable your workstation to detect Plug
& Play monitors and select Plug and Play as the monitor type.
Setting Up Your
Workstation