Rockwell Automation 6185-C_B Industrial 15 12 Inch Monitor User Manual User Manual
Page 32
32
Bulletin 6185-C and 6185-B Industrial Flat Panel Monitors
Publication 6185-5.1
To adjust the luminance of the monitor:
Press and hold either one of the dimmer buttons until the luminance is
adjusted as desired.
•
The left dimmer button reduces the luminance and the right button
increases it.
•
The green LED blinks fast when you first press the button and slows
as you reach the end of the adjustment range.
•
When you release the dimmer button for three seconds, the amber
LED blinks twice to indicate that your changes have been saved and
will be used each time the monitor is powered ON.
To turn off the monitor without turning off the power:
1. Press and hold both buttons for 2 seconds, until the monitor’s
backlight is turned OFF.
2. Press either button to turn the backlight back ON.
Table F
Interpreting the Dimmer LED
Green LED
Amber LED
Condition
On
Off
Normal Operation - The monitor is receiving a valid video
signal.
Off
On
Signal Not Received - The monitor is not receiving a valid
video signal.
On (blinking
slowly)
Off
Backlight Off - The monitor is still ON but the backlight is
powered OFF. Hold down both buttons for 2 seconds to
disable the backlight. Press either button to enable the
backlight.
On (blinking fast
then slow)
Off
Changing Dimmer Setting - When you are pressing one
of the dimmer buttons, the LED blinks fast and slows
down as you reach the end of the possible dimmer
adjustments in that direction. The light stops blinking
when you stop pressing the button, and the amber LED
blinks twice when the change has been saved. Once a
dimmer setting has been saved, it will be used each time
the display is powered ON.
Off
On (blinking
slowly)
Calibration Mode - See instructions below.