Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 118)

118 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Appendix B Accessories Installation
10. Secure it with the screws provided with the kit (F).
11. Insert the riser board connector in the onboard expansion slot making sure
the board is properly seated in the slot (G).
12. Tighten the three screws to secure the PCI/PCIe riser board assembly to
the chassis (H).
13. Reinstall the computer cover as detailed in
Reinstall the Cover on page 46 .
14. Follow the steps for
Post-configuration on page 45 .
If you are installing Then use Secure it with
A two-slot riser board The PCI/PCIe riser bracket provided with the kit Four screws
A single-slot riser board The default PCI/PCIe riser bracket Two screws
Two-slot Riser Board Single-slot Riser Board
F
F
E
F
F
E
Single-slot
Riser Board Two-slot
Riser Board
Integrated Display
Models Shown
H
H
H
G
H
H
H
G
IMPORTANT Make sure the mounting bracket does not pinch any cables under the
bracket.
If you intend to install Then
A compatible add-in card now Proceed to page 114 for instructions.
An add-in card later 1. Reinstall the rear cover.
2. Apply power to the computer.