Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 55)

Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014 55
Component Replacement Chapter 4
14. Remove the PSU (J).
15. Install the new PSU in the reverse order of the removal steps.
a. Torque the two screws to 1.4 N•m (12 lb•in) to secure the new PSU.
b. Before reinstalling the computer to the display unit, verify that the
following are properly connected:
– the two PSU power connectors and their screws
– the eDP signal and panel cables
c. Remove and replace any cut cable ties.
16. Follow the steps for
Post-configuration on page 45 .
J