Rockwell Automation 6189x Integrated Display Industrial Computers User Manual - Manual (Page 66)

66 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014
Chapter 5 UEFI Set-up Utility
SATA Configuration (AHCI mode)
Parameter
(1)
(1) See page 60 for an explanation of common buttons near the bottom of screen.
Description
SATA Mode Selection Select an operation mode for the onboard SATA controller.
In this case, the AHCI mode (default) is selected.
SATA Port (0, 1) Indicates the SATA drive connected to the SATA connector.
Port (0, 1) Enables or disables the SATA drive connected to the SATA port.
Options: Enabled (default) or Disabled
Hot Plug Enables or disables hot plug support for the SATA port.
Options: Enabled (default) or Disabled
IMPORTANT: Make sure all writes to the drive are complete before removing the
drive from the system to avoid risk of data corruption.
SATA Device Type Indicates the drive type connected to the SATA port.
Options: Hard disk drive (default) or solid-state drive