Rockwell Automation 20D PowerFlex 700H and 700S Frame 9-14 Drives Installation - A4 Size - Manual (Page 105)

Frame 11 Installation 8-7
Removing the Airflow Plate
The drive is equipped with a plate, just above the Control Frame, that directs
air flow through the drive. You may need to remove this plate in order to
access the protective covers and the power terminals. If you do not need to
remove the airflow plate, continue with
"Removing the Protective
Covers" on page 8-8 .
Task Description
Remove the T8 Torx-head screws that secure the airflow plate to the drive.
Slide the airflow plate off of the drive.
A
B
A
B
A