Rockwell Automation 20D PowerFlex 700H and 700S Frame 9-14 Drives Installation - A4 Size - Manual (Page 95)

Frame 10 Installation 7-11
Move the Common Mode Jumper to the Disconnected Position
Follow the lettered steps below to move the common mode jumper to the
disconnected position (refer to
Figure 7.6 for jumper location):
Task Description
Loosen the upper screw.
Remove the lower screw.
Move the jumper to the horizontal position.
Install and tighten the screws.
A
B
C
D
A
B
C
D
Rectifier Circuit Board
Front View of
Power Structure