Rockwell Automation TLAR Electric Cylinders Replacement - Manual (Page 8)

8 MP-Series and TL-Series Electric Cylinders Replacement Parts
Rockwell Automation Publication MPAR-IN002B-EN-P - September 2012
2. Disassemble the motor, motor flange, and coupling housing, using the following
diagram.
Replace Only the Coupling
If you are replacing the coupling only, follow these steps. If replacing the actuator cylinder go to
Replace Only the Actuator Cylinder on page 10 .
1. Remove the coupling hubs from the
motor and actuator.
2. Pull apart the new coupling.
3. Insert the new gear ring in one of the
coupling hubs.
4. Position the coupling hub with
matching diameter on the motor.
5. Position the coupling hubs with matching diameter on the actuator cylinder shaft.
Item Description Item Description
1 Motor 4 Coupling housing
2 Coupling hub 5 Gear ring
3 Motor flange 6 Actuator cylinder
1
2
3
4
2
6 5
Gear Ring
Coupling Hubs
Actuator Cylinder
Motor