Rockwell Automation 1768-CNxxx ControlNet Communication Modules - Manual (Page 9)

Rockwell Automation Publication CNET-IN005C-EN-P - July 2014 9
Chapter
1
Install a 1756 ControlNet Communication
Module
Topic Page
ControlLogix-XT Systems 11
Redundant Media 12
Installation Summary 12
Determine Module Slot Location 12
Set the Node Address 13
Install the Module 14
Connect the Module to a ControlNet Network 15
Remove the Module 17
Install the EDS File and Get Firmware Updates 19
Connect a Programming Terminal to the Network with a 1786-CP Cable 20
Connect to the Module via the USB Port 21
ATTENTION: Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II applications (as
defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is not intended for use in residential environments and may not provide adequate protection to radio
communication services in such environments.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from
accessibility to live parts. The enclosure must have suitable flame-retardant properties to prevent or minimize the spread of flame,
complying with a flame spread rating of 5VA or be approved for the application if nonmetallic. The interior of the enclosure must
be accessible only by the use of a tool. Subsequent sections of this publication may contain additional information regarding
specific enclosure type ratings that are required to comply with certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1 , for additional installation requirements.
• NEMA Standard 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by enclosures.