Rockwell Automation 2500 IntelliCENTER Software - Manual (Page 12)

12 IntelliCENTER Software
Publication MCC-UM001E-EN-P - March 2014
Install Additional Data Disks
Follow these steps to install data disks other than the initial disk that was installed with the IntelliCENTER software.
1. Insert the IntelliCENTER software data disk into the CD-ROM drive.
The Merge Data dialog box appears automatically and the Select New Database box is populated with the path
D:\Order\Item\Access\ic.mdb. This is the location of the database on the CD-ROM drive of your computer.
If there is more than one MCC lineup on the new data disk, the New Database Lineup Names pull-down menu lets you
choose which lineup is merged into the existing database on the computer.
2. Select the MCC lineup that is to be merged.
3. Click ‘Add as a new lineup’ or ‘Add to an existing lineup’.
Choose Add to an existing lineup when adding replacement units or new sections to a lineup that already exists within
the database. Otherwise, choose Add as a new lineup to have the lineup merge in as a new lineup, separate from the other
lineups in your database.
4. Click OK to merge the databases together.
The database is checked for errors. If there are errors, the database is not merged. If there are no errors, the new database
is merged with the existing database; this may take a few minutes. There is a confirmation that the databases were merged
successfully. If there is more than one lineup on the new data disk, a dialog box appears, asking if you are done merging. If
you are not, repeat the steps for additional lineups until you are done merging all the lineups.
IMPORTANT
If more than one lineup is to be merged from the data disk, each lineup has to be merged individually until all lineups have been
merged into the existing database.