Rockwell Automation FactoryTalk Metrics Line Edition Administrators Guide - Manual (Page 21)

3 • F ACTORY T ALK M ETRICS LE C ONTENT
17
•
•
•
• •
I DEAL C YCLE T IME
This value is the time required for one part to past through the workcell under ideal
conditions. Ideal Cycle Time is a real value and represents seconds. Usually, the Ideal
Cycle Time value changes only if the Part Id also changes.
G OOD P ARTS
Good Parts is the count of the first quality parts produced by the workcell.
S CRAP P ARTS
Scrap Parts is the number of parts produced by a workcell that, for whatever reason,
cannot be categorized as good parts. From a machine efficiency point of view, these parts
have no value, and the cycle time taken to produce them at the current workcell has been
wasted.
Line UDT Field Name Data Type FactoryTalk Metrics use Scheduled/Unscheduled
2 IdealCT Real Ideal Cycle Time Unscheduled
Line UDT Field Name Data Type FactoryTalk Metrics use Scheduled/Unscheduled
3 GoodParts Integer Good Part Count Unscheduled
The GoodParts tag should act like an accumulator and increase in value. This value should
never decrease unless it is reset.
Line UDT Field Name Data Type FactoryTalk Metrics use Scheduled/Unscheduled
4 ScrapParts Integer Scrap Part Count Unscheduled
The ScrapParts tag should act like an accumulator and increase in value. This value should
never decrease unless it is reset.
FTMLE Admin Guide.book Page 17 Friday, August 8, 2008 8:28 AM