Rockwell Automation SD3100 DISTRIB PWR SYS SD3100 DC PWR MODULE - Manual (Page 2)

The information in this users manual is subject to change without notice.
AutoMax™ is a trademark of Rockwell Automation
©1998 Rockwell International Corporation
Throughout this manual, the following notes are used to alert you to safety considerations:
Important: Identifies information that is critical for successful application and understanding of the product.
!
ATTENTION: Identifies information about practices or circumstances that can lead to personal
injury or death, property damage, or economic loss.
!
ATTENTION: Only qualified personnel familiar with the construction and operation of this
equipment and the hazards involved should install, adjust, operate, or service this equipment.
Read and understand this manual and other applicable manuals in their entirety before
proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: Verify that all sources of AC and DC power are deenergized and locked out or tagged
out in accordance with the requirements of ANSI/NFPA 70E, Part II.
ATTENTION: The user must provide an external, hardwired stop circuit outside of the drive
circuitry. This circuit must disable the system in case of improper operation. Uncontrolled machine
operation may result if this procedure is not followed. Failure to observe this precaution could
result in bodily injury.
ATTENTION: The system may contain stored energy devices. To avoid the hazard of electrical
shock, verify that all voltage on capacitros has been discharged before attempting to service,
repair, or remove a drive system or its components. You should only attempt the procedures in
this manual if you are qualified to do so and are familiar with solid-state control equipment and
the safety procedures in publication 70E.
ATTENTION: An incorrectly applied or incorrectly installed drive system can result in component
damage and/or a reduction in product life. Wiring or application errors–such as undersizing the
motor, incorrect or inadequate AC supply, and excessive ambient temperatures–can result in the
malfunction of hte drive equipment.
ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in damage to, or destruction
of, the equipment.
ATTENTION: This drive system contains parts and assemblies that are sensitive to ESD
(electrostatic discharge). Static control precautions are required when installing, testing, or
repairing this assembly. Component damage can result if ESD control procedures are not
followed. If you are not familiar with static control procedures, refer to Rockwell Automation
publication 8000-4.5.2,
Guarding Against Electrostatic Damage, or another adequate handbook
on ESD protection.