Installing a typical bus bar assembly – Rockwell Automation FD86N Drive Systems Enclosure Hardware User Manual
Page 22
2-8
Installing the FD86N Enclosure
Publication S-3062 – November 1997
Installing a Typical
Bus Bar Assembly
Hardware needed:
•
Five M6 or ¼-20 thread-forming screws per enclosure bay.
To install a bus bar assembly to the FD86N enclosure:
1. Place the bus bar assembly over the cutouts on the top of the FD86N
enclosure. Use the lifting points shown in Figure 2.6. Do not lift the
bus bar assembly using a hook in the bus bar holes.
2. Align the mounting holes. Refer to Figure 2.6.
3. Fasten the bus bar assembly to the FD86N enclosure using the M6 or
¼-20 thread-forming screws.
Figure 2.6
Installing a Bus Bar Assembly to an FD86N Enclosure
Front View
Rear View
Bus Bar Assembly
FD86N Enclosure Hood
Bus Bar Assembly
FD86N Enclosure
Hood
Lift Points (for Bus Bar
Assembly Only)
Typical 4 per Assembly